Unico 15 kW Electric Heating Furnace 3-Phase WON1504
- Brand: Unico
- Model: WON1504
- Unico Small Duct System
- 600 CFM
- 60 Hz
- 240V
- Single Supply Circuit
- 3 Phase
- Availability: In Stock. Ships within 2-3 days.
Other Products
-
2-2.5 Ton Slide-In Hot Water Heating Coil HW2430
Accessories
Price: $535.99
-
3-5 Ton Slide-In Hot Water Heating Coil HW-3660
Accessories
Price: $705.99
-
1-1.5 Ton Slide-In Hot Water Heating Coil HW1218
Accessories
Price: $355.99
-
2 kW Electric Heating Furnace Single Phase WON0202
Accessories
Price: $565.99
-
5 kW Electric Heating Furnace Single Phase WON0502
Accessories
Price: $625.99
-
5 kW Electric Heating Furnace 3-Phase WON0504
Accessories
Price: $619.99
15 kW Electric Heating Furnace 3-Phase WON1504
General
The electric furnaces are designed to provide primary heating or auxiliary heating in a heat pump system.The electric duct furnace is approved for attic, closet, or alcove installation, with “0” clearance to combustible materials. It can be mounted either directly to the blower module or in the main duct. The 15 and 20 kW single phase furnaces contain two supply circuits. Supply wires can be run separately for each circuit, which is the default configuration. Using two supply circuits allows the use of smaller gauge wires. In some cases, it is necessary to use smaller gauge wire to comply with building codes that limit the maximum wire size that can be used for a single circuit. The two circuits can also be joined together with a jumper bar. This is included with all dual circuit furnaces. The jumper bar allows the use of one pair of larger gauge wire, as opposed to two pairs of smaller gauge wire. Note: Circuit breakers installed in this device are for shortcircuit protection of internal wiring and to serve as a service disconnect. Circuit breakers installed within this device DO NOT provide over current protection of the supply wiring.
All Unico System furnaces include a 10-inch (254-mm) round plenum adapter and a 9½ × 9½-inch (241 × 241-mm) square plenum adapter.
Features
- Galvanized insulated sheet metal cabinet enclosure
- Can be converted to a duct heater
- Magnetic de-energizing contactors for each element
- Line level auto limit primary safety set @ 165ºF
- Line level fuse link back-up safety
- Fan interlock control, fan signal proving switch
- Circuit breakers on all units
- Time delay sequencers for a gradual “stepped” power draw (softer start)
- Low voltage terminal strip (24 volt control)
- Specially designed tight cabinet for small duct, high velocity systems
- Single Supply (all units) or dual supply (15 and 20kW)
Benefits
- Provides comfortable heat
- Can be used as primary or auxiliary heat source
- Quiet
- Efficient
- Replaces natural gas furnaces
Electric Furnace Installation
M1218 Electric Furnace Mounting
Electric Furnace Start Collar Installation
Electric Furnace Square Duct Installation
